DTF Printer Machine (30 CM) – Professional DTF Printing Solution

The starting machine, and the one that fits in a room
you already have.

Most DTF setups are two separate units – a printer,
then a shaker sitting beside it, with an operator
carrying film between them. This is both in one body,
under a metre wide. Load the film, send the job, and
it prints, powders, and cures in one continuous pass.
Nothing to hand off, nothing to misalign.

At 30 cm it’s sized for a business that’s building up
rather than already running at volume. Single-piece
orders, small brand runs, reseller work — the jobs
where a 60 cm machine would sit idle most of the day.

The feature worth paying attention to is automatic
white ink stirring. White ink pigment settles when a
machine sits, and settled pigment is the single most
common cause of clogged heads. This one keeps it
circulating on its own, which matters more than any
spec sheet number if the printer isn’t running every
day.

Hiwin guide rails, so the carriage stays quiet and
accurate over time. BYHX, Hoson or Senyang board
depending on configuration. Runs on CMYK plus white,
1440 dpi, roughly 20 sqm/hour at 4-pass.